Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
TOOL SPECIFICATIONS
All screws and nuts are metric.
MODEL
TOOL ACTUATION
SB-1842BN
SB-1850BN
SB-150SX
SB-1664FN
SB-125BN
SB-2IN1
FASTENER SPECIFICATIONS:
TOOL MODEL
BRAD SERIES
SB-125BN
BT1300
SB-1842BN
BT1300
SB-1850BN
BT1300
SB-2 IN 1
BT1300
TOOL MODEL
STAPLE SERIES CROWN WIDTH
SB-150SX
SX5035
SB-2 IN 1
SX5035
TOOL MODEL
NAIL SERIES
SB-1664FN
SB16
TOOL AIR FITTING:
These tools use a free-flow connector plug, 1/4 N.P.T. The inside diameter should be
.200" (5mm) or larger. The fitting must be capable of discharging tool air pressure when
disconnected from the air supply.
OPERATING PRESSURE:
70 to 100 p.s.i.g. (4.9 to 7.0 kg/cm
best fastener performance.
DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.
OPERATION
BOSTITCH OFFERS TWO TYPES OF OPERATION.
CONTACT TRIP
The common operating procedure on "Contact Trip" tools is for the operator to contact the work to actuate
the trip mechanism while keeping the trigger pulled, thus driving a fastener each time the work is
contacted. This will allow rapid fastener placement on many jobs, such as sheathing, decking and pallet
assembly. All pneumatic tools are subject to recoil when driving fasteners. The tool may bounce, releasing
the trip, and if unintentionally allowed to recontact the work surface with the trigger still actuated (finger
still holding trigger pulled) an unwanted second fastener will be driven.
SEQUENTIAL TRIP
The Sequential Trip requires the operator to hold the tool against the work before pulling the trigger. This
makes accurate fastener placement easier, for instance on framing, toe nailing and crating applications.
The Sequential Trip allows exact fastener location without the possibility of driving a second fastener on
recoil, as described under "Contact Trip". The Sequential Trip Tool has a positive safety advantage because
it will not accidentally drive a fastener if the tool is contacted against the work – or anything else – while
the operator is holding the trigger pulled.
MODEL IDENTIFICATION:
Refer to Operation Instructions on page 9 before proceeding to use this tool.
CONTACT
TRIP
Identified by:
BLACK
LENGTH
Sequential Trip
9.25"
Sequential Trip
9.25"
Sequential Trip
9.50"
Sequential Trip
11.25"
Sequential Trip
9.25"
Sequential Trip
9.25"
GAUGE
18
18
18
18
5-6mm
5-6mm
GAUGE
16
2
). Select the operating pressure within this range for
SEQUENTIAL
TRIP
Identified by:
GRAY
-4-
HEIGHT
WIDTH
8.5"
2"
9.5"
2"
8.75"
2"
11.50"
3"
8"
2"
8.5"
2"
FASTENER RANGE
5/8" - 1-1/4"
5/8" - 1-5/8"
5/8" - 2"
5/8" - 1-5/8"
FASTENER RANGE
1/2" - 1-1/2"
1/2" - 1-1/2"
FASTENER RANGE
1" - 2-1/2"
WEIGHT
2.38 lbs.
2.69 lbs.
2.65 lbs.
4.03 lbs.
2.12 lbs.
2.38 lbs.
Publicité
Table des Matières
