Tool Specifications - Bostitch D62ADC Manuel D'instructions

D62ADC/DS-3219/DS-3522 TOOL SPECIFICATIONS
All screws and nuts are metric.
MODEL
D62ADC
DS-3219 12.6" (320mm)
DS-3522 12.6" (320mm)
FASTENER SPECIFICATIONS:
MODEL STAPLE SERIES
D62ADC
DS-3219 B58C / B34C
DS-3522
* 7/8" (22mm) staples require Deep Clinchers
TOOL AIR FITTING:
This tool must use a male free-flow connector plug, 1/4" N.P.T. The minimum inside diameter should be .200"
(5mm). The fitting must be capable of discharging tool air pressure when disconnected from the air supply.
OPERATING PRESSURE:
The operating pressure of the tool is 70 to 100 p.s.i. (5 to 7 kg/cm
range for best fastener performance. DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.
AIR CONSUMPTION:
Model D62ADC/DS-3219/DS-3522 requires 4.0 cubic feet per minute (.113 cubic meters) of free air to
operate at the rate of 100 fasteners per minute, at 80 p.s.i. (5.66kg/cm
tool will be run to determine the amount of air required. For instance, if your fastener usage averages 50
fasteners per minute, you need 50% of the tool's c.f.m. of free air which is required for running at 100
fasteners per minute.
OPERATION
BOSTITCH OFFERS ONE TYPE OF OPERATION FOR THIS SERIES TOOL.
TRIGGER OPERATED
This is a trigger operated model cycled by actuation of the trigger. The trigger operated tool will cycle every
time the trigger is actuated.
LENGTH
9" (228mm) 8.625" (219mm)
8.86" (225mm)
8.86" (225mm)
.074" x .037"
SWC
(1.88 x .94mm)
.074" x .037"
(1.88 x .94mm)
.074" x .037"
SW7437
(1.88 x .94mm)
.090" x .040"
SW9040
(2.29 x 1.02mm)
HEIGHT WIDTH
4.5" (115mm)
4.5" (115mm)
4.5" (115mm)
WIRE SIZE CROWN WIDTH
-4-
WEIGHT
5.9 lbs. (2.5 kg)
5.45 lbs. (2.45 kg)
5.45 lbs. (2.45 kg)
FASTENER RANGE
1-3/8" 1/2" - 3/4"
(35mm) (12 - 19mm)
1-1/4" 5/8" - 3/4"
(32mm) (15 - 19mm)
1-3/8" 5/8" - 3/4"
(35mm) (15-19mm)
1-3/8" 5/8" - 7/8"*
(35mm) (15 - 22mm)
2 ). Select the operating pressure within this
2 ). Take the actual rate at which the