Health O Meter 402LB Mode D'emploi page 6

ASSEMBLY INSTRUCTIONS (CONTINUED)
Caution: It is recommended that the assembly be performed by two people. Use of a
chair is also recommended for the assembly process.
1. Carefully remove the scale platform and
pillar from the carton and place on a flat,
level, and dry surface. Locate the steel rod
at the base of the pillar. Remove the tie wrap
that holds the steel rod / finger pull loop to
the pillar.
2. Obtain a sturdy chair and place the top of
the pillar with the height rod side facing
down on the seat of the chair, as shown.
Place the platform/base perpendicular to the
platform with the front of the base resting on
the floor and the top of the platform/base
facing the top of the pillar. Remove the four
pillar nuts on the studs and set aside for use
in step 3. Align the four studs on the bottom
of the pillar with the four holes in the top of
the platform/base. Insert the studs into into
the platform/base.
Note: If a chair is not available it is
recommended that one person holds the
platform/base while another person handles
the pillar.
3. Access the underside of the scale base.
Obtain the four pillar nuts removed in step 2
and place onto the studs on the underside of
the scale base. Using the provided wrench,
tighten the pillar nuts to secure the pillar to
the base.
4. Grasp the finger pull loop on the end of the
steel rod and pull towards the lever
extension. Push the lever extension towards
the finger pull loop. Hook the steel rod to the
hole at the end of the lever extension.
Release the finger pull loop and ensure that
the steel rod and lever extension are hooked
together. Carefully position the scale to its
upright position. The scale is now
assembled. Refer to the next page to zero
balance the scale before first use.
P/N UM402LB REV20220928_web
Studs
Pillar nuts
Lever
extension
6
Tie wrap
Steel rod /
finger pull loop
Finger pull
loop
Steel rod