Ir Remote Control (Optional) - Cameo ROOT PAR 4 Manuel D'utilisation

SYSTEM INFORMATION (System Info)
Starting from the main display, press MODE to enter the main menu. Now use UP and DOWN to
select the menu item System Info and confirm with ENTER.
--------Menu-------
DMX Address
DMX Mode
DMX Delay
Standalone
Slave
Settings
System Info
This will take you to the submenu for accessing the system information (see table, selection with
UP and DOWN, confirm with ENTER, change status with UP and DOWN, confirm with ENTER).
System Info
Firmware = Displays device
firmware
Tempera- = Displays
ture temperature of
LED unit
Op Hours = displays
operating time

IR REMOTE CONTROL (optional)

Aim the infrared remote control directly at the infrared
sensor on the front of the spotlight. The maximum range
is approximately 8 metres. In DMX and slave modes, the
spotlight's IR sensor is deactivated. The infrared remote
control directly controls the internal standalone modes
Auto/Sound, Static and Color Preset.
BL/ON/OFF (Blackout)
Press the BL button to switch off all LEDs (blackout), re-
gardless of the operating mode enabled via remote control.
Press the BL button again to reactivate the previously
selected mode.
SP (Speed)
Six-level speed setting for the color change programme
Color Jumping (Ju), Color Fading (Fa) and Auto Programme
(Au). Level 1 provides a slow color-change sequence. Press
again to activate level 2 for a faster color-change sequence, and repeat for levels 3, 4, 5 and 6,
whereby level 6 provides the maximum color-change sequence speed.
Firmware
V1.xx
LED xxx °C / xxx °F
Unit °C (= display in degrees Celsius)
°F (= display in degrees Fahrenheit)
xx:xx h Displays total operating time in hours and
minutes
19