INSTALLATION INSTRUCTIONS
B.Drive
3/4" (19mm) or
screws through frame holes into window sash (Fig.8).
Fig.8
C.To secure lower sash in place, attach right angle
sash lock with 3/4" (19mm) or 1
shown(Fig.9).
D.Cut
Window sash seal foam
space between the upper and lower sashes (Fig.10).
Fig.10
All manuals and user guides at all-guides.com
1/2" (12.7mm) locking
/2" (12.7mm)
screw as
Fig.9
and insert it in the
FOAM SEAL
If AC is Blocked by Storm Window
Add wood as shown in Fig.11, or remove storm
window before air conditioner is installed.
If Storm Window Frame must remain, be sure the
drain holes or slots are not caulked or painted shut.
Accumulated Rain Water or Condensation must be
allowed to drain out.
Removing AC From Window
Turn AC off, and disconnect power cord.
Remove sash seal from between windows, and
unscrew safety sash lock.
Remove screws installed through frame and frame-
lock.
Close (slide) side panels into frame.
Keeping a firm grip on air conditioner, raise sash
and carefully remove.
Be carefully not to spill any remaining water while
lifting unit from window. Store parts WITH air
conditioner.
Storm window
frame or other
obstruction.
7
SASH
1-1/2"min
Board
thickness
(38 mm)
as required,
for proper
pitch to rear,
along entire
sill. Fasten
with nails or
screws.
Fig.11