Safety Precautions - MAGNAWELD SMART Serie Mode D'emploi

SMART SERIES

SAFETY PRECAUTIONS

Be Sure To Follow All Safety Rules In This Manual!
• Safety symbols found in the manual are used to identify potential hazards.
• When any one of the safety symbols are seen in this manual, it must be understood that there is
Explanation Of Safety
Information
• The possessor of the machine is responsible for preventing unauthorized persons from
• Persons using the machine must be experienced or fully trained in welding / cutting they have to
Explanation Of Safety
Symbols
Indicates a potentially hazardous situation that could cause injury or damage.
ATTENTION
In case if no precaution is taken, it may cause injuries or material losses / damages.
Specifies notifications and alerts on how to operate the machine.
IMPORTANT
Indicates a serious danger. In case if not avoided, severe or fatal injuries may occur.
DANGER
• Read the user manual, the label on the machine and the safety instructions carefully.
• Make sure that the warning labels on the machine are in good condition. Replace missing and
Comprehending Safety
Precautions
• Learn how to operate the machine, how to make the checks in a correct manner.
• Use your machine in suitable working environments.
• Improper changes made in your machine will negatively affect the safe operation and its
• The manufacturer is not responsible for the consequences resulting from the operation of the
device beyond the specified conditions.
Electric Shocks
May Kill
• Wear dry and sturdy insulated gloves and working apron. Never use wet or damaged gloves and
• Wear flame-resistant protective clothing against the risk of burning. The clothing used by the
• Do not work alone. In case of a danger make sure you have someone for help in your working
• Do not touch the electrode with the bare hand. Do not allow the electrode holder or electrode to
• Never touch parts that carry electricity.
• Never touch the electrode if you are in contact with the electrode attached to the work surface,
floor or another machine.
• By isolating yourself from the work surface and the floor, you can protect yourself from possible
electric shocks. Use a non-flammable, electrically insulating, dry and undamaged insulation
• Do not connect more than one electrode to the electrode holder.
• Clamp work cable with good metal-to-metal contact to workpiece or worktable as near the weld
• Check the torch before operating the machine. Make sure the torch and its cables are in good
• Do not touch electrode holders connected to two machines at the same time since double
• Keep the machine turned off and disconnect cables when not in use.
• Before repairing the machine, remove all power connections and / or connector plugs or turn
• Be careful when using a long mains cable.
www.magmaweld.com
a risk of injury and the following instructions should be read carefully to avoid potential hazards.
accessing the equipment.
read the user manual before operation and follow the safety instructions.
damaged labels.
longevity.
Make certain that the installation procedures comply with national electrical standards
and other relevant regulations, and ensure that the machine is installed by authorized
persons.
working aprons.
operator must be protective against sparks, splashing and arc radiation.
environment.
come in contact with any other person or any grounded object.
material that is large enough to cut off the operator's contact with the work surface.
as practical.
condition. Always replace a damaged, worn torch.
open-circuit voltage will be present.
off the machine.
Safety Precautions 5
USER MANUAL
EN