Machine Features; Soft Start - MAGNAWELD SMART Serie Mode D'emploi

SMART SERIES

3.10 Machine Features

• Allows MIG, MMA and TIG welding.
CC / CV Construction
• There are 3 job memories that can be saved.
Memory
• It provides a user-friendly operation with its classic, smart and synergistic MIG / MAG modes.
Variety of Usage Functions
• Prevents the formation of knocked and jerky start by increasing the wire speed gradually.

Soft Start

• Thanks to the intelligent performance control, the welding parameters of the machine are continuously
Smart Performance
monitored and analyzed.
• If compulsory conditions occur, the machine switches to the protection mode in order to extend its life and
protect itself against malfunctions.
• This protection is indicated by a thermal led warning on the machine panel.
• The machine is reactivated after 2 minutes of safe time.
• The internal temperature of the machine is continuously measured. The cooling fan speed is increased or
Smart Fan
decreased according to the measured temperature. When the temperature is below a certain degree, the
phase will be stopped completely. The amount of dust entering the machine is reduced by this function. As
the machine life is prolonged, energy will be saved. The fan provides continuous cooling performance
during welding.
• With the control connection option, you can also change your welding current / welding voltage through
Current/Voltage Control over the Torch
the torch without going near your machine.
• Provides ease of use with its robot compatible structure.
Robot Compatibility
• Source and media information is stored in real time form thanks to its magNET-ready structure.
Magnet Compatibility
Some values can be read on the LCD panel on the machine front, while other information (Original
Equipment Activity-OEE, Welding Parameters-WR, Quality, etc.) can be stored and monitored or reported
on the magNET platform. (Optional)
• Suitable for operation with generators. The kVA operating value should be determined by referring to the
Operation with generators
technical specifications.
• Protected against missing or incorrect phase.
Protection
• If the mains voltage is too high or too low, the machine automatically protects itself by giving an error code
Voltage Protection
on the display. By this means, no damage is caused to the machine components and long life of the machine
is ensured. After the ambient conditions have returned to normal, the machine functions will also be
activated.
www.magmaweld.com
Operation 35
EN
USER MANUAL