Chauvin Arnoux F 07 Notice De Fonctionnement page 30

HOLD Function active
HOLD
PEAK ON in V, A and Adp. in MIN/MAX mode if the
measurement of the peak value is selected
MAX Indicates the display of a maximum value in
MIN/MAX mode
MIN Indicates the display of a minimum value in
MIN/MAX mode
AC Fixed: measurement in AC manual mode
Flashing: measurement in AC automatic mode
DC Fixed: measurement in DC manual mode
Flashing: measurement in DC automatic mode
AC + DC measurement in AC + DC manual mode
T° Temperature measurement
INT Temperature measurement when the
terminals are not connected or if the
connected thermocouple is defective
EXT Temperature measurement when the
thermocouple is connected
Semi-conductor test on position Ω
m Scale factor < 1 in adapter function
k Scale factor > 1000 in adapter function
I I I I I The Buzzer
Different tones are emitted according to the function given
to the buzzer :
- Short and medium sound: valid key
- Short and high-pitched sound: prohibited key
- Short and low sound: Quit MIN/MAX mode
- 2 short and high-pitched beeps: validation of a
configuration parameter
- Short and medium sound every 400 ms: voltage
measured higher than the unit's guaranteed safety voltage.
- 5 short and medium recurring beeps: automatic
deactivation of the instrument
- Short and medium sound: measured continuity value,
lower than programmed threshold, short-circuit junction
during semi-conductor test.
- Modulated medium continuous sound: value measured
in volts, higher than 45 V peak when the V-Live function
is selected.
30
30