Installation And Electric Connections; Maintenance; Cleaning - MACAP M7D Serie Instructions Originales

3 INSTALLATION AND ELECTRICAL CONNECTIONS
Installation must be carried out by trained technical personnel.
Installation must be carried out in strict compliance with the safety provisions currently in force
in the country of use, with
particular reference to the accident and fire prevention regulations and electricity authority
regulations.
Place the appliance on a flat surface to ensure it is
perfectly stable. Before connecting the appliance to the
mains:
- align the hole of the bell with one of the holes of the
adjusting ring-nut
(see figure F1). Check that the fan does not prevent
lowering the adjustment disc stopper pin, otherwise
change the hole.
Fasten, using the appropriate screw.
- make sure the switch is off (position 0) and that the
voltage and frequency data given on the data plate are commensurate with that of the mains
supply.
The power cable must be connected to the ground plate, which must be perfectly efficient and
in compliance with current safety regulations.
4

MAINTENANCE

Only trained personnel must carry out the maintenance work. If, during maintenance, any worn
components need changing, only original spare parts must be used.
5

CLEANING

ALWAYS UNPLUG THE APPLIANCE FROM THE MAIN SWITCH BEFORE CLEANING.
DO NOT PLACE THE APPLIANCE IN WATER. DO NOT USE ANY ABRASIVE PRODUCTS AS THEY
COULD DAMAGE THE SURFACE OF THE GLOSSY PARTS ON THE APPLIANCE.
F1
15
ENGLISH