Publicité
STEP 1
Using the chart, find the distance
between screw locations, mark with
a pencil, and confirm they are level.
Note: Make sure to fasten to
the thick portion of your door.
Existing cabinet shelves may
need to be adjusted so the spice
rack does not interfere with
the door closing properly after
installation (See Figure A).
STEP 2
BEFORE pre-drilling make sure
mounting locations will work
correctly by lining up a bottom
screw hole with a mounting clip,
and while holding the clip in place
shut the door to confirm the
bracket will NOT interfere with
the door closing. If clip interferes,
repeat step one, and adjust clip up
as needed.
STEP 3
Pre-drill bottom mounting holes
using 1/8 drill bit. (Use caution not
to drill through the door) and attach
the mounting clips to the door using
(2) #6 x 1/2" Pan Head Screws.
#2
#2
#2
STEP 4
Insert the rack into bottom
mounting clips, attach top mounting
clips to the rack, and while holding
in place and making sure the screw
locations are in the THICK portion
of the door. Mark screw locations
with a pencil.
STEP 5
Remove top clips, pre-drill top
mounting holes using 1/8 drill bit
(Use caution not to drill through the
door), reattach top clips to the rack
and attach to the door using (2) #6 x
1/2" Pan Head Screws
(See Figure B).
Once in place, adjust interior
cabinet shelving as needed.
#2
#2
#2
2
FIG. A
Hole Spread Dimensions
Use the chart below to determine
the mounting clip hole spread for
the unit purchased.
#2
#2
#2
Customer Service: 800-626-1126 | rev-a-shelf.com
565-8-52
7-7/8"
(200 mm)
565-10-52
10-5/8"
(270 mm)
565-14-52
13-5/8"
(346 mm)
FIG. B
Mounting clips
Thick portion
of door
Mounting clips
Publicité
