Samsung RSH7ZNRS Mode D'emploi page 13

Close Main Close Main
Water pipe Water pipe
Close Main Close Main
Water pipe Water pipe
4. After connecting the water supply to the water
fi lter, turn your main water supply back on and
dispense about 1l to clear and prime the water
fi lter.
Connecting the water line to the
refrigerator
1. Remove the dust cap from the water line on the
rear of the unit and fi t a compression nut from the
install kit.
2. Remove the water pipe from the install kit and fi t a
compression nut to one end.
3. Join the two pipes together using the compression
joint from the install kit ensuring that the joint is
water tight.
4. Join the other end of the install pipe to the main
water supply and turn on the water to check for
leaks.
Remove Remove
Loosen a Loosen a
cap cap
Water Line Water Line
from unit from unit
Water Line Water Line
from Kit from Kit
Only connect the water line to a drinkable water
source.
If you have to repair or disassemble the water
line, cut off 6.5mm of the plastic tubing to
make sure you get a snug, leak-free connection.
Before being used, the leakage in
these places should be examined
CAUTION
• Samsung Warranty does not cover WATER LINE
• The cost of connection to a water supply is at the
• Please contact Plumber or Authorised Installer for
• If Water leakage occurs due to improper
NO GAP NO GAP
INSTALLING THE WATER
DISPENSER LINE
For Exterior model
Parts for water line Installation
No gap No gap
Connecting to the water supply line
Connect the water pipe with coupler and tap.
1. Close the main water tap.
2. Connect coupler "A" to the tap.
INSTALLATION.
customer expense, unless included in the delivery
charge (refer to the delivery agreement with the
seller)
the installation if needed.
installation, Please contact installer.
Water line fi xer and screws
Water line
Purifi er lock-clip
CAUTION
The water line must be connected to the cold
water pipe. If it is connected to the hot water
pipe, it may cause the purifi er to malfunction.
Pipe connector
Purifi er
_13
setting up