Human Touch PC 500 Manuel D'utilisation Et D'entretien page 6

take a seat
Adjust the recline angle
Before adjusting the recline angle, be sure there is nothing located directly behind or beneath the chair.
Gently pull the electric recline lever toward you to recline, or push away from you to incline. Release the lever
when you reach the desired angle. The chair automatically stops when you reach the maximum recline or the
full upright position. In the full upright position, the legrest automatically folds inward for easy entrance and
exit from the chair.
NOTE: Lean back against the backrest before reclining the chair. Do not put any extra pressure on the
footrest while reclining, as this may prevent the footrest from properly deploying and locking.
When adjusting the footrest up and down, you may notice a slight bumping sensation.
This is caused by the footrest locking mechanism, and is perfectly normal.
humantouch.com
8
Using your Human Touch Perfect Chair
the chair to the desired position. The Perfect Chair cradles you in zero-
gravity comfort, with your feet above your heart—the ultimate neutral-
posture position for stress relief.
Adjust the headrest
While seated, reach up with both hands and grasp both sides of
the headrest. You will feel the rigid frame beneath the soft head
pad. Grasping the rigid frame, tilt the headrest forward or back-
ward for maximum comfort. The headrest remains in this position
until you adjust it again.
Getting out of the perfect chair
While seated, push gently forward on the electric recline lever
until the backrest automatically stops in a full upright position and
the footrest automatically stops in a vertical position (the backrest
stops before the footrest). Use the arms for support when getting
up from the chair.
9
is easy. Just take a seat and adjust