Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To Deactivate Alarm Setting
1. Press the [SET] key to for 3 seconds and the LCD will be shown CODE SETUP .
2. Press & release the [CH+] key for seven (7) times to view the ALARM SET
page.
3. Upon the LCD shown as ALARM SET , press the [SET] key once.
4. The LCD shown as ALARM ON , press the [CH+] key to shown as
ALARM OFF .
5. Press the [SET] key once, the LCD shown as SUCCESS and back to normal
operation and the symbol of "ALARM" will be cancelled.
6. The alarm is automatically deactivated after the setting procedure.
Press the [SET] key to for
3 seconds
NOTE : Press the [ESC] key for escape and the selected setting will not be
stored.
CH SCAN / SHOWVIEW
When using BC-838 Plus under TV or CD or ASAT or DSATmode, press [CH
SCAN] key once. The indicator of "CH SCAN" will turn ON, the BC-838 Plus will
send [CH+] signal in every 2 seconds. It will be turning OFF if any key is pressed
and the BC-838 Plus will stop channel scan.
If you press the [CH SCAN] key over 1 sec., it will send one time of [CH+] signal
only.
When using BC-838 Plus under VCR or DVD mode, press [SHOWVIEW] key
once. It will drive you to perform the operation as per your original VCR or DVD.
SHIFT FUNCTION
You can operate the BC-838 Plus for secondary function as per your original
remote control function. Simply press the "SHIFT" key once and the indicator of
"SHIFT" turn ON. Then press on other key on BC-838 Plus to work on desired
function.
NOTE : You may need to try out for each of the key once to find out desire
function as per your original remote control.
TELETEXT AND FASTEXT
The function of TELETEXT and FASTEXT should operate exactly as your original
remote.
RETAIN OF MEMORY
Upon changing the batteries or you are not on time to replace new batteries for
BC-838 Plus , all your setting for devices code number, learned functions, etc...
will be retained. You need not to worry about to start all over again for setup.
(Except the Weekly, Hour, Minute, these are all required to set up again after you
placed the new batteries on the BC-838 Plus ).
TIME OUT
In the set up mode, if you did not press any key within 30 secs., the system will
returns to normal mode. In normal mode, if did not press any key within 15
seconds, the LCD will be shut down for power saving.
19
Press & release the [CH+] key
for seven (7) times
Press the [SET] key to confirm
Press the [SET] key once
Press the [CH+] key
Publicité
Table des Matières
