Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Press the [SET] key to for
3 seconds
Press the [SET] key to
save the working code
SETTING UP BY LEARNING
The BC-838 Plus comes with a complete library of pre-programmed codes. After
you have set up the BC-838 Plus for your device, you may find that there are
one or more keys that you had on the original remote control, which do not have
a place on the BC-838 Plus keypad.
The BC-838 Plus offers a special learning feature that allows you to copy almost
any function from your original remote control onto the keypad of the
BC-838 Plus . Except the [SET] key and Device mode keys.
Before you start :
• Make sure your original remote control is working correctly.
• Make sure neither your BC-838 Plus , nor your original remote control is pointing
at your device.
To Learning (direct):
For example: To copy the "PIP" function from your original TV remote control
onto the
key of your BC-838 Plus .
1. Place the BC-838 Plus and your original remote control on a flat surface.
Make sure the ends which you normally point at your device are facing each
other. Point the original remote to the front center head of the BC-838 Plus
(see picture below). Keep the remotes at a distance of 2 to 5 cm.
2. Press the [SET] key to for 3 seconds and the LCD will be shown CODE SETUP .
3. Press & release the [CH+] key for two (2) times to view the LEARN MODE
page.
4. Upon the LCD shown as LEARN MODE , press the SET] key once. The LCD
now shown TV IR LEARN . Press the [Device] key to select a desired mode
(TV, VCR, DVD, CD, ASAT, DSAT, CBL, etc..). In this case is [TV] key.
5. Press the [SET] key once and the BC-838 Plus LCD shown as TV LEARN KEY .
6. Press the "MUTE" key on the BC-838 Plus remote where you want to place
the learned function, the LCD shown as TV LEARNING .
7. Press & hold the key that you want to copy (Example: PIP key on your original
remote control).
8. After learning is OK, the LCD shown as SUCEESS for 3 seconds then shown
as TV LEARN KEY If you want to copy other functions within the same mode,
simply repeat steps 6 and 7 pressing the next key you want to copy by learning.
9. In step 6, by pressing the [SET] key or Device mode key, you will exit the
learning mode and back to normal operation of BC-838 Plus .
15
Press & release the [CH+] key
Press the [SET] key once for
GROUP SEARCH
Press the [SET] key once
Press the [CH+] key once
Publicité
Table des Matières
