Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
* If not, the LCD shown as ERROR means that the code number may
not correct.
6. Aim the BC-838 Plus at your TV and press the [POWER] key. Your TV should
turn off. If none of the keys or only some of the keys operate your TV, please
repeat Steps 1-5, trying each code listed for your brand until you find the one
that operates your TV.
7. Your BC-838 Plus is now programmed to operate your TV. Write down your
TV code on the Quick Code Reference as listed on this BC-838 Plus
Instruction Manual for future reference.
8. To program other equipment, repeats the Steps 1-7 for your VCR, DVD, CD,
ASAT, DSAT, CBL, and or your second TV or VCR or SAT, etc..
NOTE : To exit from the DIRECT CODE SETUP during the code entering, just
press the [ESC] key once and back to normal operation mode.
Press the [SET] key to for
3 seconds
Write down the code no. for your device :
TV
VCR
DVD
SAT
CD
DECODER
LD
AUX
IMPORTANT FOR AUTO ALL SEARCH AND GROUP SEARCH
Before the use of either Auto All Search or Group Search , please read careful
of below requirement:
Device Mode for TV
Device Mode for VCR
Device Mode for DVD
Device Mode for CD
Device Mode for ASAT
Device Mode for DSAT
Device Mode for CBL
Device Mode for AUX
SETTING UP BY AUTO ALL SEARCH
This Auto All Search method checks all its preprogrammed codes to find the
code that will operate your equipment automatically. This method may take a
few minutes.
1. Make sure your TV is switched on (not on standby).
2. Aim the BC-838 Plus at your TV.
3. Press the [SET] key to for 3 seconds and the LCD will be shown CODE SETUP .
4. Press & release the [CH+] key once to view the CODE SRCH page.
5. Upon the LCD shown as CODE SRCH , press the [SET] key once, the LCD
shown as TV ALL SRCH .
13
Press & release the [SET] key
Code error
Assigned for TV searching.
Assigned for VCR searching.
Assigned for DVD searching.
Assigned for CD searching.
Assigned for ASAT searching.
Assigned for DSAT searching.
Assigned for CBL/SAT searching.
Need to set up the selected device code first in
order to search proper for assigned device
Input 3 Digit TV code
Code accepted
Publicité
Table des Matières
