R&G CP0161BL Guide Rapide page 2

Please note that the way the kit is packed does not necessarily represent the way of mounting to the bike
P
LEASE NOTE THAT IN CASES WHERE KITS ARE PACKED WITH RUBBER WASHERS HOLDING THE COMPONENTS ONTO
–
THE BOLT THE RUBBER WASHERS SHOULD BE THROWN AWAY
Right Hand-side (as you sit on the bike

Remove side fairing panel & remove black plastic cover.

Remove the two engine mounting bolts (please be aware the two spacers behind the engine may be loose and
fall out, they have to be reused).

Take the R&G block with the larger cut-out and fit to bike using two M10 x 80mm long cap head(these are
the bolts with the round heads) bolts and tighten to no more than 40Nm torque.

You can leave the black plastic scoops off the bike if you wish. Alternatively please follow the next step
concerning using the templates for cutting.

Take the RHS template and tape to the plastic cover to mark approximate position of hole to be cut (as shown
above right).

Cut hole in cover a little bit at a time using a Dremel or similar tool until cover will fit over block. (note if
you do not want to cut the cover you may leave it off the bike) .

Refit fairing.

Take the M10 x 80mm hex head bolt, one M12 shake-proof washers and 1x 10mm washer and slide washers
up to head of bolt (the shake proof washer should sit against the protector on assembly).

Push bolt through one of the protectors

Take the smaller of the aluminium spacers (20mm long) and slide over bolt up to protector.

Screw into block previously fitted.

Tighten bolt until you feel some compression from inside the protector. Turn a little more so that you feel the
compression increase slightly. Then apply a quarter turn. Do not overtighten as damage can occur to the
bike. Do not exceed 40nm of torque
POSITIONED AS IN PICTURE 'C' WITH BIGGER END TOWARD FRONT OF BIKE.

Repeat for Left Hand-side except using block with smaller cut-out, LHS template, larger aluminium spacer
and 1 M10 x 80mm cap head bolt, 1x M10 x 90mm hex head bolt and 1x M10 x 50 cap head bolt.
Due to the risk of cross threading of bolts etc; we recommend that our products be fitted by one of our official
dealers or a qualified mechanic.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
!
)
. PLEASE NOTE THE CRASH PROTECTORS MUST BE
Issue 3 (NSY) 10/02/2012
R&G Racing
www.rg-racing.com Email: info@rg-racing.com
.