tormek SVD-186 R Manuel D'instructions page 5

Turning Cutters
When sharpening turning cutters, the shaft (12) replaces
the tool holder (1) and it is mounted in the sleeve (2) with
the screw (8). The tool is fixed with the screw (13).
Mounting the jig
Loosen and remove the screw
(8) and the tool holder (1).
Mounting the cutter
Cutters with 4 mm ( 5/32 ") holes
are centered by the M4 screw.
Sharpening
Rotate the jig all the time during the sharpening so you achieve an
even grinding around the whole circumference. Use only a light
pressure for the best result. Slide the jig sideways on the Univer-
sal Support so the grindstone wears evenly.
Insert the shaft (12) into the
sleeve (2). Note: Position the
sleeve according to the picture!
Cutters with 5 and 6 mm
( 3/16 "–¼") holes are centered on
the first shoulder on the shaft.
Mount the screw (8). Lock the
shaft with the Allen key (14)
when tightening.
Cutters with 8 mm ( 5/16 ") holes
are centered on the second
shoulder on the shaft.
Smooth the back on the
machined, flat outside of the
grindstone. Move the cutter in
order to use the whole surface
of the stone.
EN
5