Remote Control - Marmitek Connect TS41 Guide Utilisateur

4.3 Right
1. Power: Press this button to
switch the Connect TS41 on or to
standby mode.
2. Input: Use this button to select
which audio input is switched to
the audio output.
3. Optical Out: Connect your audio amplifier or powered
speakers to this output using an optical (Toslink) digital audio
cable (not supplied).
4. IR: IR sensor for receiving the supplied remote control's infra-
red signals. For correct operation, make sure it is placed in your
remote control's line of sight.
4.4 Back
1. DC 5V: Connect the power
adapter (included) and plug it into
the mains.

4.5 Remote control

1. Power: Press this button to switch the
Connect TS41 on or in standby mode.
2. Input 1 ~ 4: Use this button to select which
audio input is switched to the audio output.
Connect TS41™
5