Biesemeyer T-Square Système commercial de guide Type 2 Manuel D'utilisation page 9

FENCE ASSEMBLY AND ADJUSTMENT
1. Place fence clamp handle end cap (OO) Fig. 11 on post
(PP). Then place fence clamp handle body (QQ) on end
cap (OO) and place other end cap (SS) on body (QQ). Place
fence clamp handle screw (TT) into end cap (SS) all the way
down and tighten into post (PP). Finished handle should
look like (RR).
2. Align fence side (C) Fig. 12, with the miter slot on the table
saw and lock fence in position. Using a measuring tape (D),
measure the distance from the saw blade to the fence side.
3. WITHOUT MOVING THE FENCE, attach hairline pointer (E),
Fig. 13 to fence crossarm (F) using two #10-32 x 3/8" round
head screws and flat washers (G). Screws go through the
slotted holes in the pointer and into the threaded holes (H)
in the crossarm. Using the measurement from Step 2, align
the black line in the pointer to the same measurement on
the guide tube tape and securely tighten screws.
IMPORTANT: CHECK TO MAKE CERTAIN THAT
THE MITER GAGE SLOTS IN THE SAW TABLE ARE
PARALLEL WITH THE SAW BLADE. CHECK WITH THE
INSTALLATION MANUAL THAT CAME WITH YOUR
SAW FOR INSTRUCTIONS.
4. The fence (C) Fig. 14, must be adjusted so it is parallel
to the miter gage slot. Slide the fence until the bottom
edge is in line with the edge of the miter gage slot and
push down on locking handle (B). Check to see if the
fence (C) is aligned with the miter slot the entire length
of the table. If an adjustment is needed, lift fence (C) off
the guide as shown in Fig. 15. Slightly tighten or loosen
adjusting screws (J) or (K), using a 3/16" Allen wrench, not
included. Replace the fence on the guide tube and check
again. Repeat this adjustment until you are certain the
fence is parallel to the miter gage slot. NOTE: Very little
movement of the adjusting screws is necessary to
adjust the fence.
ASSEMBLY
OO
9
PP
SS
QQ
FIG. 11
D
FIG. 12
G
H
FIG. 13
C
FIG. 14
RR
TT
C
E
F
B