Biesemeyer T-Square Système commercial de guide Type 2 Manuel D'utilisation page 11

8. The distance the fence is positioned away from the saw
blade is indicated by the witness line (S) located in cursor
(E), Fig. 19. To calibrate the cursor to the saw blade, make
a test cut with the fence locked in position. Measure the
width of the cut piece. Adjust the cursor by loosening screws
(G), adjusting the cursor until the witness line is aligned
with the same marking on the scale as the cut piece.
Tighten the two screws (G). Repeat until the width of the cut
piece matches the measurement indicated by the witness
line.
B
ASSEMBLY
FIG. 19
P
FIG. 20
11
9. Apply grease to locking handle (B) and camfoot (P) Fig.
20, monthly to insure long lasting smooth operation.
10. Apply paste wax to the fence sides and the unpainted
guide tube sliding surfaces weekly. Meguiar's Professional
Paste Wax (M-2611) is recommended. Also, saw table and
extension table surface should be waxed.
G
E
S