Biesemeyer T-Square Système commercial de guide Type 2 Manuel D'utilisation page 8

7. Position the table leg (I) to the closed in corner of the
extension table (J) as shown in Fig. 7. The vertical wall of
the angle plate should be against the end wall of the fence
table (section running from front to back of saw).
8. Attach the table leg to the table board with four #8 x 1/2"
self-tapping screws (K). Carefully drill through the holes
in the vertical plate and table edge with a 1/4" drill. Using
the #10-32 x 1-3/4" pan head screws, 2 flat washers (one
inside and one outside) and #10-32 hex nuts, bolt the legs
solidly to the fence. Repeat this process for the remaining
leg.
9. Loosely insert 4 3/8"-16 x 1" hex head screws and 3/8"
flat washers into the threaded holes in the extension
wing. Place table assembly (L) Fig. 8, in position between
the two rails, as shown. Make sure end of table is flush
against saw table (M). The mounting plate on the table
opposite of the legs will slide over the previously inserted
bolts. Hand tighten these bolts with the table in position.
Using a straight edge make sure table (L) is in the same
plane and level with saw table (M). Lightly tap up or down
and adjust leg leveling screws. When you are certain that
the table is level and in the same plane as the saw table,
tighten bolts. Using a bar clamp, clamp the opposite end
J
FIG. 7
R
FIG. 9
ASSEMBLY
I
K
of the table between the front and rear rails. Then drill
1/4" holes through the front and rear of the extension table
using holes (Q) provided in rails as a template. NOTE:
Number of holes (Q) in the front and rear rails will vary
depending on the length of the rails you purchased.
10. After the holes have been drilled in the edge of the front
and rear extension table board, fasten front rail to table
using the 1/4-20 x 1-1/2" flat head Phillips screws, flat
washers, lock washers and hex nuts (R). Fasten the rear
rail to the table board using 1/4"-20 x 1-1/2" hex head
screw, two flat washers (one inside and one outside), lock
washer and hex nut.
11. Lay the guide tube (B) Fig. 10, on the saw table as shown,
and line up the threaded holes (S) on the bottom of guide
tube with the through holes (T) on the front rail.
12. Position the guide tube (B) on the front rail and fasten the
guide tube to the rail using the 1/4-20 x 1/2" long button
head screws and lock washers.
B
8
M L
Q
FIG. 8
S
T
FIG. 10