Summit SU82083 Mode D'emploi page 8

LADDER SUPPORT
1. Position the Top Ladder Section as shown in
figure 16. The ladder will slide into the welded
brackets on the Platform. The Top Ladder Section
has two couplers welded on and does not have a U
Bracket.
2. Attach using two 2" bolts and lock nuts
shown in figure 17. Leave these hand tight for
now.
2" BOLTS, LOCK NUTS -
HAND TIGHT
2 3/4" BOLTS, LOCK NUTS -
HAND TIGHT
19
FINAL ASSEMBLY
1. GO BACK AND WRENCH TIGHTEN ALL BOLTS FROM PAGES 3 - 5. DOUBLE CHECK BOLTS TO ENSURE THEY
ARE PROPERLY FASTENED!
PG 8
Hardware Needed
5/16"-18 - 2" Bolt
5/16"-18 - 2 3/4" Bolt
as
TOP LADDER SECTION
(PN 82074.11)
17
COMPLETED PLATFORM
/ SEAT ASSEMBLY
LADDER
SUPPORT
BAR
(PN 82074.10)
3. Attach the Ladder Support Bars next. These bars run from the Ladder Column
to the Platform as shown in figure 18.
4. Secure the Support Bar to the Platform using
location. (see figure 19)
5. Repeat Steps 3 - 4 for the other side.
- 2 5/16"-18 - Lock Nut
- 4
2 3/4" bolts and lock nuts
www.summitstands.com
- 6
16
18
at each