Summit SU82083 Mode D'emploi page 10

STABILIZER BAR
1. Position the Female Section of the Stabilizer bar as
shown in figure 24. The Stabilizer bar will attach to the
welded U Bracket. Slide the bar into the bracket and
line up the hole.
2. Secure using one 1 3/4" bolt and lock
(see figure 25) Do not overtighten.
3. Position the Male Stabilizer bar as shown (figure 26).
Line up the bolt holes and secure using the
as shown in figure 27. The Stabilizer bar has several
pin
holes to accommodate different tree sizes.
1 3/4" BOLT, LOCK NUT -
WRENCH TIGHTEN
25
1/4" WIRE LOCK PIN
27
FOAM SEAT / PADS
1. Position the Foam Seat inside the frame as shown in
figure 28.
2. Wrap the Velcro straps around the Seat Support to
attach.
3. Wrap the three included pads around the frame in
the green areas as shown in figure 28. Pads can be
repositioned to fit your needs.
WARNING
!
The foam seat included with this treestand is
removable for storage. DO NOT leave your seat
outdoors when it is not being used. Replace seat
cushion every two (2) years.
PG 10
Hardware Needed
1/4"-20 - 1 3/4" Bolt
1/4"-20 - Lock Nut
24
nut.
Wire Lock
26
- 1 Wire Lock Pin
- 1
STABILIZER
FEMALE SECTION
(PN 82074.15)
STABILIZER
FEMALE SECTION
STABILIZER
MALE SECTION
(PN 82074.14)
FOAM SEAT
(PN 82074.17)
-1
U BRACKET
28
www.summitstands.com