General Remarks; Cleaning And Maintenance; Problem Solving - MPM MSO-07M Mode D'emploi

GENERAL REMARKS

1. Soft and too ripe fruit will cause that the juice will not be clear.
2. It is advisable to remove all leaves and tops from vegetables before putting them into the
juicer.
3. Do not squeeze the juice from the rhubarb and currants.
4. If the juice is too thick, dilute it with mineral water.
DISASSEMBLY OF THE JUICER
1. Turn off the appliance using
2. Wait until the screen stops
3. Remove the pusher from the
4. Remove the handle
5. Remove the screen housing
6. Thoroughly wash and clean these items.

CLEANING AND MAINTENANCE

1. Turn off the appliance before cleaning.
2. Main housing can be cleaned with a damp cloth (if necessary, you can add a small amount
of detergent).
3. All parts in contact with food should be washed thoroughly after each use with warm water
and a little detergent, preferably immediately after juicing.
4. Do not use strong cleaning detergents, acetone, alcohol, sharp materials, etc.
5. The screen should be cleaned thoroughly after each use. Do not wash the screen in the
dishwasher!
6. Do not immerse the base of the appliance in water or other liquids!
7. When juicing carrots and beets, white parts of the juicer may experience discolouration.
8. After cleaning the juicer it should be reassembled.

PROBLEM SOLVING

Description of problem
The appliance does not turn on after
turning the switch
The motor emits an unpleasant odour
during the first few uses
The appliance heats up during
operation
The juice contains a lot of pulp
the power switch and disconnect it from the power source.
7
completely.
3
opening for feeding the fruits and vegetables.
1
and the top cover
8 2
with the screen
4
Possible cause
1. Improperly installed juice bowl/screen
2. Improperly fitted top cover
3. Improperly fitted pulp reservoir, juice bowl
and housing
This is normal
1. Supply voltage too low
2. Too many fruits/vegetables in the appliance
3. Ingredients are pushed in with too much force
4. Thermal protection against overheating the
motor
1. Damaged screen
2. Too much pulp on the screen
. Then the waste container can be removed
.
3
1. Install the juice bowl/screen in the correct way
2. Install the top cover correctly
3. Install the pulp reservoir, juice bowl and housing
properly
If the motor still gives off an unpleasant odour after
the first few uses, take your appliance to the nearest
authorised service
1. Check the supply voltage
2. Switch off the device. Remove excess fruits/vegetables
3. The products should be pushed in with a smaller force
4. Turn off the device for 20-30minutes and turn on again
1. Replace the screen
2. Clean the screen
.
9
Solution
25