Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
MATERIALS
A
1
Mainframe
B
1
Coupling spacer
D
4
M12 x 45mm x 1.5mm 10.9 grade Bolts, Flat Washers and Spring Washers
E
3
M5 x 40mm Bolts
CB
2
M16 x 60 x 2.0 Bolts, Nuts and Lock Washers
Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball, which
dimensionally conforms to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar. – may also be used with a Z52B
adjustable and a type approved universal coupling.
FITTING
1.
Loosely attach Mainframe (A) to lower face of bumper beam using bolts (D).
2.
Ensuring Mainfarme (A) is aligned correctly with bumper fully tighten all bolts. (120Nm).
3.
Bolts (E) are supplied to enable fitment of electrical socket.
Recommended torque settings:
M16 - 200 Nm Grade 10.9: M12 – 120Nm
Fitting
Instructions
µW0001VW72-FIT$011106270000ÌÄ
W0001VW72-FIT$011106270000
For VW Amarok fitted with factory
Bumper step
VW72B
TOWBAR
2011-
Publicité
Manuels Connexes pour Witter VW72B
Sommaire des Matières pour Witter VW72B
- Page 1 M16 x 60 x 2.0 Bolts, Nuts and Lock Washers Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball, which dimensionally conforms to A50-1 with a ‘D’ and 'S' value greater than or equal to that of the towbar. – may also be used with a Z52B adjustable and a type approved universal coupling.
- Page 2 Boulons M16 x 60 x 2.0, écrous et rondelles freins Remarque : Cet attelage doit être utilisé avec une boule de remorquage Witter (référence produit Z11) ou une boule de remorquage Classe A50-1 ou A50-X se conformant dimensionnellement à A50-1 avec une valeur ‘D’ et 'S' supérieure ou égale à...