Witter VW77U Instructions De Montage

MATERIALS
A 1 Main Crossbar
B 2 Side arms
C 2 M12 x 40mm x 1.75p Bolts, Lock Washers, Washer & Witter Cage Nut Retainer & M12 Square Nut
D 2 M12 x 40mm x 1.75p Bolts, Lock Washers, Washer & Witter Cage Nut Retainer & M12 Square Nut
E 4 M12 x 35mm x 1.75p Bolts & Serrated Flange Nut.
ZE 1 Flip Up Electric Plate Kit
ZN 1 Neck Kit
FITTING
1. Pull back interior trim to allow access to large plastic nut. Unscrew to enable removal of the rear light clusters. Unclip
wiring and slide lights out.
2. Remove 7 torque screws from around each wheel arch / mud guard. Three of which have nuts.
3. Remove plastic plugs from lower edge of the bumper.
4. Remove the bumper, unplugging any wiring connected to it.
5. Remove the bumper beam and return to customer.
6. Assemble cage nuts from C to sidearms B (as per separate fitting instruction). Slide side arms down the chassis with
pointed edge facing upwards (as per illustration) and attach loosely using the remaining fixings C.
7. Assemble cage nuts from D to Crossbar A then attach crossbar to the sidearms using remaining fixings from D and
fixings E
8. Attach chosen neck option (ZN) and electric kit (ZE).
9. Fully tighten ALL fixings to their correct torque settings.
10. Refit bumper with the bumper cut as shown.
Recommended torque settings: Grade 8.8 bolts: M8 - 24Nm, M10 - 52 Nm, M12 - 80 Nm, M14 - 130 Nm, M16 - 200
Nm Grade 10.9: M12 – 120Nm, M10 – 70Nm M8- 35Nm
Fitting
Instructions
µW0001VW77U-FIT$011302210000:Ä
W0001VW77U-FIT$011302210000
TOWBAR
For Volkswagen Golf VII
2013-
VW77U