Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. Install hitch – Raise the hitch into position aligning holes to the studs on the end panel. Loosely install (8) factory M12 flange nuts to the hitch, see Figure 1.
4. Tighten all M12x1.5 fasteners with torque wrench to 68 ft.lb. (92 N*m).
5. Trim fascia –Using a tape measure, marker, and die grinder, measure, mark, and trim the bottom cover as shown in Figure 2.
©2022 Horizon Global™ Corp - Printed in Mexico
Proper torque is needed to keep the hitch secure to the vehicle when towing.
L C
of Vehicle
��
5
"
��
��
6
"
��
Sheet 8 of 27
76925NP
06-24-22
Rev. A
Publicité
Table des Matières
