Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Always wear SAFETY GLASSES
when installing hitch
Factory M12
flange nuts
Hitch
Fasteners
typical
both sides
1. Remove Fascia -
(a) Using a 10 mm socket, remove (8) bolts from bottom of the fascia.
(b) Using a flat head screwdriver, remove (3) rivets from the outside of wheel well liner and (1) rivet from inside of wheel well liner, per side. Using a 10 mm socket remove
(1) bolt inside of wheel well liner, per side.
(c) Open tailgate. Using a T30 torxbit, remove (1) screw from rear trim panel at the center. Remove the plastic trim.
(d) Remove plastic cover from both driver and passenger side panels. Using a plastic trim tool, remove bolt cover from cargo tie hook. Using a 12 mm socket. remove (1)
bolt from that hook, per side.
(e) Remove taillights – Remove cover from passenger side panel. Using 8 mm socket with extension remove (3) hex nuts that hold the taillight from behind of the panel,
per side. Remove taillights by disconnecting the wiring harness.
(f) Use plastic trim tools to remove the fascia starting at the outer edges near the wheel wells and gently pull the fascia. Disconnect wiring Harness while removing the
fascia.
2. Remove bumper beam – Use 18 mm socket remove (4) M12 flange nuts from bolts of bumper beam on end panel, per side. Remove bumper beam and return to vehicle
owner. *Tow eye will be inoperative after bumper beam removal. Please use chain ring on the hitch as alternative.
3.
Install hitch – Raise the hitch into position aligning holes to the studs on the end panel. Loosely install (8) factory M12 flange nuts to the hitch, see Figure 1.
4.
Tighten all M12x1.5 fasteners with torque wrench to 68 ft.lb. (92 N*m).
5.
Trim fascia –Using a tape measure, marker, and die grinder, measure, mark, and trim the bottom cover as shown in Figure 2.
6.
Reinstall fascia, taillights, plastic covers, plastic trim and all fasteners.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which
has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. This product complies with safety
specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2022 Horizon Global™ Corp - Printed in Mexico
Installation Instructions
PART NUMBERS: 76925
End Panel
Figure 1
Qty. (2)
①
Qty. (2)
②
Qty. (2)
③
④
Qty. (1)
Qty. (1)
⑤
��
5
"
��
6
Figure 2
Proper torque is needed to keep the
hitch secure to the vehicle when towing.
Sheet 4 of 27
76925NP
Fastener Kit: 76925F
Bolt
M12x1.75x100 mm, CL10.9
Flat Washer 7/16''
Prevailing Torque Nut
M12x1.75, CL10
Warning Card
Warning Label
L C
of Vehicle
��
"
��
06-24-22
Rev. A
Publicité
Table des Matières
