Special Features - Etac immedia TwinSheet4Glide Instructions D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 47
Notice

Special features

Always check the product before use and after washing.
Never use a defective product. If the product shows signs of
wear-and-tear, it must be scrapped.
Read these instructions carefully.
It is important that carers receive instruction in manual
handling. Etac offers advice and training in the safe use of the
product. For further information, contact Etac.
Always use the correct manual handling techniques
Encourage the user to assist where possible.
To ensure that the user feels safe and that every manual activity
is smooth, always plan the manual handling in advance.
Material and cleaning
Material:
Absorption: 2200 ml/m².
Microfiber top side: Polyester
Middle layer: 80% polyester/20% viscose
Barrier: Polyurethane
Back side: Nylon
Handles: Polyester
Assembling system: Hook and loop.
NylonSheet: Nylon, polyester.
The product should be checked regularly, preferably each time it
is used, and especially after washing.
Check that there is no damage to seams or fabric.
Never try to repair a product yourself.
Never use a defective product.
There is a risk that the user may slide off. Never leave
the user alone on the edge of the bed.
Never leave TwinSheet4Glide or a nylon sheet on the
floor.
Always conduct a risk assessment, and ensure that
the assistive product can be used for the intended
user and, in combination with other devices, is safe
for both user and carers.
It is recommended that the guard rail is in place when
the user is left on the glide system, unless a risk
assessment has found that the user can be safely left
on the glide system without the need of guard rails.
Always lock the glide system when you have
completed the transfer.
Do not use TwinSheet4Glide as a sling.
To reduce sliding to the side, if the head end is
elevated, fit the corner straps around the bed
mattress.
Always remove the "Loop Washing Strap" after
washing and drying and before use.
Ensure that the 2 Velcro parts can be fastened.
If in any doubt - please contact Etac.
Washing instructions:
Recommended to wash the product before use.
Shrinks 5%. Do not use fabric softener.
This product can be cleaned with a solvent-free cleaning agent
with a pH level between 5 and 9, or a 70% disinfection solution.
During washing and drying the Velcro must be
assembled or use the "Loop Washing Strap".
8

Publicité

Table des Matières
loading

Table des Matières