Installing The Plastic Wedges; Adjusting The Feet; Electrical Connection - Beko RFNE290T34XP Manuel D'utilisation

Installation
3.2. Installing the
plastic wedges
Plastic wedges supplied with the
product are used to create the distance
for the air circulation between the
product and the rear wall.
To install the wedges, remove the
screws on the product and use the
screws supplied together with the
wedges.
Insert the 2 plastic wedges onto the
rear ventilation cover as illustrated in
the figure.

3.3. Adjusting the feet

If the product stands unbalanced after
installation, adjust the feet on the front
by rotating them to the right or left.

3.4. Electrical connection

WARNING: Do not make
A
connections via extension
cables or multi-plugs.
WARNING: Damaged
B
power cable must be
replaced by the Authorized
Service Agent.
If two coolers are to be
installed side by side, there
C
should be at least 4 cm
distance between them.
Our company shall not be liable
for any damages that will arise
when the product is used without
grounding and electrical connection
in accordance with the national
regulations.
Power cable plug must be within easy
reach after installation.
Do not extension cords or cordless
multiple outlets between your
product and the wall outlet.
10 /18 EN
Refrigerator/User Manual