Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Steps
NOTE: Actual application may vary slightly from illustrations.
Reposition the hood shield with the tabs sliding BETWEEN the hood and rubber seal and align with holes.
3
Locate the (4) INBOARD flanges.
4
Insert (4) screws and washers through the rubber gasket, hood shield, and into the hood. Securely tighten.
hood shield
hood seal / gasket
washer
self tapping
5
screw
DO NOT OVER TIGHTEN
Locate the (2) OUTBOARD flanges.
6
Page 2 of 3
Publicité
Table des Matières
