Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Steps
Remove hood shield from hood. Remove the corresponding factory installed rubber seal retaining fasteners that were marked in Step 2.
NOTE: Some applications may require additional fasteners to be removed in order to fully access the holes underneath.
3
Center hood shield on hood, and slide hood shield flanges UNDER
the rubber seal. Align hood shield flanges with holes in hood.
4
Close hood. Adjust hood bump stops to raise hood as needed.
6
Care and Cleaning
• Wash only with mild soap & dry with a clean cloth.
© 2018 by MacNeil IP LLC
NOTE: Actual application may vary slightly from illustrations.
NOTE: Exercise extreme caution not to tear
or damage the rubber seal when separating
from hood.
Install a fastener at each flange location.
5
Install bump ons at pre-cleaned locations on the
7
Page 2 of 2
Hood
Hood Shield
Rubber Seal
Fastener
Do not overtighten
painted hood surface.
X6
Publicité
Table des Matières
