Table des Matières
Publicité
THE CONTROLS
The Vacuum/Accessory Switch
This switch is located on the left side of the control
panel. To turn the vacuum motor and pump motor on,
press the bottom of the switch. To turn the vacuum motor
and pump motor off, press the top of the switch.
The Spray/Brush Motor Switch
The spray/brush switch is located in the center of the
control handle. To turn on the spray/brush intermittently,
press the top of the switch and hold for the length of time
you want the floor spray/brush to run. To turn on the spray/
brush continuously, press the bottom of the switch. To turn
the spray/brush off, press the center of the switch.
NOTE: The vacuum/accessory switch must be in the "I"
position before spray will work.
The Vacuum Hose Connector
The vacuum hose connector is on the center right hand
rear of the machine.
The Solution Hose Connector
The solution hose connector is located in the center in the
rear of the machine. This connection is used to hook up
optional auxiliary floor tools.
Recovery Tank Drain
Remove hose from rear of machine. Place over drain and
open valve.
Solution Tank Drain
Remove the hose from the rear of the machine. Place over
drain.
Brush Adjustment
Adjustment is located to the front right side of the machine.
Pull spring loaded pin and place in selected slot. If breaker
trips, move adjustment one slot higher.
Variable Pump Pressure (Deluxe model only)
The control knob is located on the right side of the control
panel. To increase pump pressure turn the knob clock-
wise; to decrease pump pressure turn the knob counter-
clockwise. If streaking occurs, increase pressure setting.
Page 18
CLARKE TECHNOLOGY Image 16 230V Operator's Manual
Publicité
Table des Matières
