Uline H-6896 Manuel D'instructions page 2

ADD-ON UNIT ASSEMBLY
1. Bolt add-on unit door frame to starter unit door
frame by inserting three long hex head bolts through
open holes in one door frame and into threaded
hole in other door frame. (See Figure 3)
Figure 3
ANCHORING TO CONCRETE FLOOR
1. Verify that bulk storage locker is positioned in the
desired location. Mark floor where holes will be drilled.
2. Using a 5/16" diameter masonry drill bit, drill a hole
in all marked locations approximately 2.5" deep.
3. Clean out debris and dust from inside the holes.
4. Insert anchor bolt and anchor sleeve through the
holes in the locker into the drilled hole so that the top
of the sleeve is flush with floor and threaded bolt sticks
out of the floor. Slightly tap down the anchor bolt with
a hammer if needed. (See Figure 5)
Figure 5
5. Slide washer over each anchor bolt. Then tighten nut
until anchor bolt is secure.
PAGE 2 OF 12
ASSEMBLY CONTINUED
SECURING TO FLOOR OR WALL
2. Bolt side panel to door frame by inserting four
short hex head bolts through side panel holes into
threaded holes in door frame. (See Figure 4)
Figure 4
3. Tighten all bolts fully.
SECURING TO WALL
1. Verify that bulk storage locker is positioned in the
desired location. Mark wall where holes will go.
2. Drill a hole in all marked locations approximately
1.5" deep.
3. Using a Phillips head screwdriver, mount locker to
wall using (4) masonry screws on each side panel.
(See Figure 6)
Figure 6
1122 IH-6896