Dispensing Operations - modbar pour over system Manuel De Fonctionnement

4. Dispensing Operations

WARNING
The machine must not be dipped
in, nor splashed with, water in
order to clean it. For cleaning
operations, please follow the
instructions listed below very
carefully.
WARNING
This machine is designed only for
hot drinks.
1) Dispensing
Once the installation procedures have
Dispensing can be actuated by pressing either
Button 1 or Button 2. The buttons can be
14
set to dispense a pre-recorded program, or
to dispense manually. (See Profile Selection
Screen)
To begin dispensing, press the desired button.
Dispensing can be cancelled at any time by
pressing the button again.
2) Flow Control
Flow rate can be adjusted via the flow
control valve located on the tap port on the
back of the module. To restrict flow, turn
the flow control nut on the end of the valve
clockwise. To increase flow, turn the flow
control nut counter-clockwise.
Note: If machine has been in use, this valve may
be hot!