Table des Matières
Publicité
Use Footmuff
see images
54
1. For easier assembly of the footmuff, remove the armbar,
unbuckle the harness and remove the shoulder harness
pads, crotch pads.
2. Before placing the footmuff on the stroller seat, unzip and
open the front cover of the footmuff.
3. Place the footmuff on the stroller seat and pull the shoulder
harness webbing and buckles through the slots on the
footmuff.
54
Reassemble the shoulder harness pads, crotch pads and and
attach the armbar.
4. Zip on the front cover of the footmuff.
5. Fold the footmuff flap over the stroller armbar.
Detach & Assemble Soft Goods
see images
-
55
66
1. Remove armbar cover shown as
2. Open the zipper which is on the rear panel of canopy.
!
Adjust backrest to the lowest position to be convenient to
remove soft goods.
3. Remove calf support cover.
4. Open the buckle which is on the bottom of seat.
!
Please keep support board well, must assemble support
board when assembling soft goods.
To re-assemble seat soft goods, follow the steps above in
-
reverse
66
55
27
54
55
56
57
58
65 66
Cleaning and Maintenance
see images
67
!
To clean stroller frame, use only household soap and warm
water. No bleach or detergent. Please refer to the care label
for instructions on cleaning the fabric parts of the stroller.
!
Removable soft goods can be washed by machine. No
bleach. Do not twist the seat cover and inner padding to dry
with great force. It may leave the seat cover and inner
padding with wrinkles.
!
From time to time, check your stroller for loose screws, worn
parts,torn material or stitching. Replace or repair the parts as
needed. Periodically wipe clean plastic parts with a soft
damp cloth. Always dry the metal parts to prevent the
formation of rust if the stroller has come into contact with
water.
!
Excessive exposure to sun or heat could cause fading or
warping of parts.
!
If stroller becomes wet, open canopy and allow to dry
thoroughly before storing.
!
If wheels squeak, use a light oil (e.g., Silicon Spray, antirust
oil, or sewing machine oil). It is important to get the oil into
the axle and wheel assembly.
!
When using your stroller at the beach or other sandy/dusty
environments, completely clean your stroller after use to
remove sand and salt from mechanisms and wheel
assemblies.
67
28
Publicité
Table des Matières
