Remote Control Operation - Sharp FP-N25CX Manuel D'utilisation

OPERATION

REMOTE CONTROL OPERATION

• When you press the POWER ON/OFF Button, a short
beep will sound and operation will start in AUTO Mode.
POWER ON/OFF Button
To stop, press the POWER
ON/OFF Button again.
A long beep will sound and
operation will stop.
Auto (Fan Speed) Button
The fan speed switches au-
tomatically depending on the
amount of impurities in the air.
Manual (Fan Speed) Button
The fan speed can be
switched among Silent, Low,
and High settings.
Quick Auto Button
The operation mode is effec-
tive when quick removal of
impurities in the air is de-
sired.
Plasmacluster Ion mode Selections
Auto
When pressed, the unit will switch between
Clean Mode and the Ion Control Mode auto-
matically depending on the amount of impuri-
ties in the air as detected by the odor sensor.
Clean Mode will operate for 1 minute when
the Auto function is selected.
Ion Control
When pressed, the unit will constantly oper-
ate in Ion Control Mode.
The Plasmacluster Ion Indicator Light is green.
POWER ON/OFF
Fan Control
OFF
AUTO MANUAL TIMER
POLLEN
QUICK AUTO
Plasmacluster
CLEAN
AUTO OFF
ION CONTROL
Clean
When pressed, the unit will con-
stantly operate in the Clean Mode,
in which the same numbers of posi-
tive and negative ions are dis-
charged. The Plasmacluster Indica-
tor Light is blue.
Off
The generation of ions will cease
and the Plasmacluster Indicator
Light will go out.
E-14
Operations available with
the Remote Control
• AUTO
• MANUAL
• POLLEN
• OFF TIMER
• QUICK AUTO
Plasmacluster Ion mode
selections
• AUTO
• CLEAN
• ION CONTROL
• OFF
Transmitter
Pollen Mode Operation
Button
See Page E-12
Off Timer Button
The set time switches every time
the button is pressed as shown
below.
1 hour 4 hours
Cancel 8 hours
• The indicator light shows the
remaining time.
Note: By manually selecting ei-
ther Ion Control or Clean
Mode, this will lock the unit
into the selected mode and
will not change to the other
even if room condition
changes.