Care & Maintenance - Power Fist 8683005 Mode D'emploi

V1.0
6. Remove the handle and stow in the bracket on the main post (#20).
7. Push/pull the crane to the destination. Move slowly to prevent the load
from swinging. Stop moving if the load begins to swing and do not
resume until it the load is still. Resume moving, but at a slower pace.
8. Lower the boom arm by gradually turning the hydraulic jack's release
valve counterclockwise. Pause lowering and position the load before
allowing it to come to a rest.
9. Unhook the crane from the load and lower the boom completely to
protect the ram from corrosion.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier
to control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when
servicing.
3. Follow instructions for lubricating and changing accessories.
4. Only use accessories intended for use with this tool.
5. Maintain the tool's labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd.
For replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
HYDRAULIC RAM MAINTENANCE
Monthly maintenance is recommended for the hydraulic ram. Any
restrictions due to dirt, rust, etc. can cause the either slow movement or
extremely rapid jerks, damaging the internal components. The following
steps are designed to keep the pump maintained and operational.
1. Lubricate the cylinder and the pumping mechanism with light oil.
2. Visually inspect for cracked welds, bent, loose, missing parts or
hydraulic oil leaks.
3. Inspect the hydraulic ram immediately if it was subjected to an
abnormal load or shock load.
Visit www.princessauto.com for more information
1 Ton Shop Crane 8683005
9