Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
9081555
of the ram, leakage from the pump assembly or shifting of the frame.
A qualified technician should examine and repair any problems with the
pump itself.
OPERATING THE PRESS
IMPORTANT! Ensure that you read, understand and apply the safety
instructions and warnings before use.
1.
Lift or lower the bed frame (#8) until it is in position. Insert a bed frame
pin (#9) into the left and right posts beneath the bed frame. Lower the bed
frame so it rests on the bed frame pins.
2.
Place the heel blocks (#7) on the bed frame, then insert a workpiece on
the heel blocks.
3.
Close the release valve on the pump by turning it clockwise.
4.
Pump the handle (#27) or pedal (#22) until the ram nears the workpiece.
5.
Align the workpiece and ram to ensure center-loading.
6.
Pump the handle or pedal to apply load onto the workpiece.
7.
Do not exceed the maximum piston stroke. If you see a red line on the
piston, retract the ram and adjust the bed to bring the workpiece closer to
the ram.
8.
When the work is done, stop pumping the handle or pedal. Slowly
and carefully remove load from workpiece by turning the release valve
counterclockwise in small increments.
9.
Once the ram has fully retracted, remove the workpiece from the bed
frame.
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3.
Only use accessories intended for use with this tool. Follow instructions
for changing accessories.
www.princessauto.com / 1-800-665-8685
HYDRAULIC SHOP PRESS
V1.0
Page 10
Publicité
Table des Matières
