Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Floor Joist
2. Install the Base
Locate the position on the wood support where the base will be
installed. Use the base as a guide to mark the mounting hole
locations.
Drill 1-1/2" (380 mm) deep holes with a 3/16" drill bit (provided)
using the marked locations as the center point.
Secure the base to the support with the screws and washers
provided.
Verify the base is level and tighten the screws.
Kohler Co.
Screw
Washer
Base
Ø 3/16"
Mounting Hole
Wood Support
5
1144501-2-C
Publicité
Table des Matières
