Installation - PRESIDENT THOMAS FCC Manuel D'utilisation

Welcome to the world of the new generation of CB radios. The
new PRESIDENT range gives you access to top performance
CB equipment. With the use of up-to-date technology, which
guarantees unprecedented quality, your PRESIDENT THOMAS
FCC AM/FM is a new step in personal communication and is the
surest choice for the most demanding of professional CB radio
users. To ensure that you make the most of all its capacities,
we advise you to read carefully this manual before installing
and using your PRESIDENT THOMAS FCC AM/FM.
A) INSTALLATION
1) WHERE AND HOW TO MOUNT YOUR MOBILE CB RADIO
a) You should choose the most appropriate setting from a simple
and practical point of view.
b) Your CB radio should not interfere with the driver or the passengers.
c) Remember to provide for the passing and protection of different
wires (e.g. power, antenna, accessory cabling) so that they do
not in any way interfere with the driving of the vehicle.
MOUNTING DIAGRAM
d) To install your equipment, use the cradle (1) and the self-tapping
screws [2] provided (drilling diameter 3.2 mm). Take care not to
damage the vehicle's electrical system while drilling the dash
board.
e) Do not forget to insert the rubber joints (3) between the CB and
its support as these have a shock-absorbing effect which permits
gentle orientation and tightening of the set.
f)
Choose where to place the microphone support and remember
that the microphone cord must stretch to the driver without inter-
fering with the controls of the vehicle.
- Note: As the transceiver has a frontal microphone socket, it can
be set into the dash board. In this case, you will need to add an
external loud speaker to improve the sound quality of commu-
nications (connector EXT.SP situated on the back panel: C). Ask
your dealer for advice on mounting your CB radio.
6