Publicité
Les langues disponibles
Les langues disponibles
STEP 2
Measure your cabinet opening
and then measure your door
size. Take the difference of
these two numbers and divide
it by 2. This number is your
door overlay or inset gap
(See Fig. C).
STEP 3
If the door is larger than
the opening ADD the
door overlay to the Step 1
dimensions.
If the door is smaller than
the opening SUBTRACT the
inset gap from the Step 1
dimensions.
STEP 4
Mark screw locations to the
thick portion of the door
based off your hole spread
from figure A, pre-drill pilot
holes, and attach door with
provided screws (See Fig. D).
Minor adjustments like skew
and tilt can be made on the
bracket mounting bolts.
2
Difference ÷ 2
(overlay or inset)
FIG. C
Cabinet
opening
Difference
FIG. D
Door size
Hole spread
Mark screw
locations
12400 Earl Jones Way
Louisville, KY 40299
rev-a-shelf.com
Customer Service: 800-626-1126
Publicité
