Verdemax SE20 Manuel D'emploi page 31

ASSEMBLY
Charging process
NOTE:
The batteries (optional; depending on the de-
livery scope) are not fully charged on delivery.
Before first use, fully charge the batteries. See
charger instruction manual.
Chargers are exclusively suitable to charge
these replaceable batteries:
Li-Ion 20.2 - 20.4. Charging any other bat-
tery is not allowed.
Do not use this product in any other way as
stated for normal use. Not observing general
regulations in force and instructions from this
manual does not make the manufacturer liable
for damages.
Chain saw assembly
Note: After unpacking, check the contents
for completeness and possible transport
damage.
If a part is missing or damaged, please contact
the seller.
• Open the packaging and remove the device
carefully.
• Remove the packaging material as well as
the packaging and transport bracing (if avail-
able).
• Check that the delivery is complete.
• Check the device and accessory parts for
transport damage.
• If possible, store the packaging until the war-
ranty period has expired.
Installation: Installing the guide bar and saw
chain
WARNING!
• The teeth of the saw chain are very sharp!
Protective gloves must be worn during all work
on the chain.
Risk of injury!
• An incorrectly installed saw chain leads to
uncontrolled cutting behaviour by the device!
When fitting chain, observe the prescribed
running direction!
• Place the chainsaw on a level surface.
EN
Fig. 2: Release the Chain locking screw (15)
using tooling(18) and take off the chain cover
(13).
Fig. 3: Turn the chain tensioning screw clock-
wise to move the guide bar as close to the chain
wheel as possible.
Fig. 4: Place the saw chain(17) around the guide
bar(16),starting at the top section of the
bar.Insert the saw chain in the circumferential
groove.When inserting the chain, observe the
correct running direction of the chain.
31
Original instructions