Changing The Blades - Husqvarna AUTOMOWER 520H Guide Rapide

To pair with the product when using Husqvarna Fleet Services™ app:
1. Download the Husqvarna Fleet Services™ app and Automower® Connect app from AppStore or GooglePlay.
2. Create a Husqvarna Fleet Services™ account (www.husqvarna.com).
3. Set the Main switch to position 1.
4. Log on to the Husqvarna Fleet Services™ app, select the plus sign (+) and then "Automower® Pro".
5. Obey the instructions in the app.
Note: The Bluetooth® pairing mode is active for 3 minutes. If pairing has not been successful within this time period, switch
off the product. Wait until the LED status indicator is not lit, and then switch on the product again.
3. PR E PA R AT I O N S A N D CAU T I O N S
• Remove stones, branches, tools, toys or other objects on the lawn that can damage the blades.
• Warning signs shall be placed around the working area of the product if it is used in public areas. The signs shall have the
following text: Warning! Automatic lawn mower! Keep away from the machine! Supervise children!
• If there is a risk of a thunderstorm, it is recommended to disconnect all connections to the charging station.
4. CL E A N I N G A N D M A I N T E N A N C E
WARNING: Switch off the product (Main switch, position 0).
CAUTION: Never use a high-pressure washer to clean the product. Never use solvents for cleaning.
4.1 C L E A N I N G
• Clean the charging station regularly from grass, leaves, twigs and other objects that may impede docking.
• Clean around the front and rear wheels.
• If the charging plates appear to be burnt or coated, clean them using a fine grade emery cloth.
1. Set the Main switch to position 0.
2. Lift the product onto its side.
3. Clean the blade disc and chassis using for example a dish brush. At the same time, check that the blade disc rotates
freely in relation to the foot guard. Also, check that the blades are intact and can pivot freely.

4.2 CHANGING THE BLADES

1. Set the Main switch to position 0, and turn the product upside down.
2. Rotate the skid plate so that its holes align with the screws for the blade.
3. Remove the 3 screws. Use a straight slot or crosstip screwdriver.
4. Remove each blade and screw, and fasten new blades and screws.
5. Check that the blades can pivot freely.
5. L E D I N D I CATO R L A M P
The LED indicator lamp on top of the product shows the current status of the product.
Refer to chapter 6.5 in the Operator's manual for suitable actions.
The LED indicator lamp on the charging station shows the current status of the charging station and loop wire.
Refer to chapter 6.4 in the Operator's manual for suitable actions.
O PE R AT I O N
For information about the operation of the product, refer to chapter 4 Operation in the Operator's manual.
T RO U B L ES H O OT I N G
If the product does not operate as expected, refer to chapter 6 Troubleshooting in the Operator's manual.
QG_P2C, P2CH_2021.indd 4 QG_P2C, P2CH_2021.indd 4
E N
2020-04-27 15:38:15 2020-04-27 15:38:15