ShelterLogic ShelterCoat 28'W x 16'H Peak Mode D'emploi page 8

9. INSTALL EASY-HOOK EARTH ANCHORS:
A. The anchors should be positioned at the four corners and the remaining should be spaced evenly on both
sides of the shelter.
B. Using the provided steel driving rod and a sledge hammer, drive each anchor into the ground leaving
approximately 8 inches of cable exposed above the surface.
C. Wrap the cable around the driving rod and pull up on the cable to set the anchor.
D. After the anchors are firmly set, wrap the cable around the foot, then close with a cable clamp. Be sure to
remove all slack from cable.
If the ground is too hard, dig a hole
with a shovel or post hole tool.
Optional: Fill with cement.
For best results, ShelterLogic
recommends using one Easy
Hook ™ Drive Anchor at each
leg for a stronger, more secure
installation.
WARNING: Serious injury to persons or property
could result if cover is installed and shelter is not
completed and is left unattended. Shelter must
be securely anchored until completed.
®
Fig.9
Page 8 05_GP-AA-XXXXXXA-028XXX16_G1