First Start-Up - Starmix 677 Notice D'emploi

Dear Customers,
Thank you for choosing one of our high-quality STARMIX products.
The STARMIX 677 is an especially efficient hand sweeping machine with a permanent brush drive that is
simple to operate and can be used for all even and hard surfaces. The unique Turbo sweeping system with
circular brushes and sweeping rolls guarantees double cleanliness. The circular brushes collect all kinds of
dirt from the road, from fine dust to empty cans, wet leaves and even heavy garbage. The sweeping rolls
collect fine dust, and, in addition, ensure the optimal overhead filling of the dirt container. In order to
guarantee a long service life of your sweeping machine, the following operating instructions must be
observed.

First start-up

Assembly of the sliding handle
Fold the the handle fitting (item 7.13) forward to an angle of 45° and pull it. Push the catch spring of the
sliding handle (item.7.12) and connect the sliding handle (item.7.11) with the handle fittings (item 7.13) by
engaging the catch spring. To fit handle to the sweeper frame (Pos 1.12) fold the handle forward to an angle
of 45° towards the front brushes, the handle holder will snap into position. To fix the handle move the
handle back to normal sweeping
Connect the battery cable
To avoid self-discharge the battery, the sweeper will be delivered with the positive terminal
battery cable. Disconnect the battery before initial use. Without connected battery-cable, the
sweeper keeps without electrical function and the battery can not be loaded.
For connecting the battery, open the hood (item 1.13) by pulling forward on the front lower
edge of the hood and swinging upward. Open the battery holder. The wiring of the battery
is done by attaching the battery cable to the connector tab on the battery. (Red = positive (+), black =
negative pole (-) then attach the battery holder by pushing on and snapping. Do not change the cables on
the battery, otherwise the machine may be damaged and the warranty on the components expire.
Charging the battery
Charge the battery prior to the first start-up. Please see the chapter "charging the battery".
Operation
Height adjustment of the brooms
The STARMIX 677 sweeping machine is factory adjusted for even surfaces. The brush pressure can be
freely adjusted with the adjusting button (item 1.11).
Step 1-2: new brushes for all even surfaces
Step 3-4: new brushes for wet leaves, sand, uneven floors (e.g. washed-out concrete)
Step 5-8: older brushes for readjustment of the worn brush parts.
Please ensure that the brushes rest only lightly on the floor. A lower brush position
does not bring about better cleaning results and instead may increase the wear on the
brushes.
Stand 03/2013 -10-