Technical Data - Starmix 677 Notice D'emploi

of the brush). Next, pull the tilted wheel (item 4L/R) strongly and remove it from the machine together with
the shaft. Strongly pull off the circular brushes (item 2L/R) together with the tooth sleeves and the clutch
(item 3L/R) from the journal.
Note: On the inside of the frame (item1.12) and on the inclined wheels and on the clutches (item 3.10) you
will find markings for L and R. The circular brushes are marked on the bottom with L/// or R\\\ depending
on the direction of the bristles. During the assembly, make sure that the coordination is correct. The
assembly is carried out in reverse order. Fit the circular brushes into the journal, insert the clutch (item 3.10)
and the tooth sleeves and engage the tilted wheels (please make sure that the wheels are in the correct
position) – and you are ready to go.
For the replacement of the sweeping roll, press on the stop bracket of the roll seating (item 8.15). During the
assembly, ensure that the bristles are not pinched laterally and that the snap bracket is returned to its correct
starting position.
What should be done when the unit does not run smoothly?
1. Check the sweeping pressure adjustment
2. Clean the unit and remove spooled cords etc.
3. Spray the gear parts with the special STARMIX lubricant spray.
4. Make sure that the direction of rotation of the circular brushes (after repair) is correct
Disassembly of the sliding handle
To disassemble handle fold the handle forward to an angle of 45° towards the front brushes, and pull out the
handle holder (Pos. 7.13) from the frame (Pos 1.12).
Guarantee
4 year warranty on the circular brooms
2 year warranty on all other parts in accordance with the EU regulations
(wear excluded)
Maintenance
Prior to each use
- Check the machine for damage
- Check the circular brushes and the brush rolls for jammed parts and deadlocked dirt particles
that could hinder the rotation of the brushes
- ensure that the sweeping pressure adjustment is correct
After each use
- charge the battery
- empty the waste container
Additionally, every 10 operating hours
- clean gear (item 3 + 4) and spray it with STARMIX lubricant spray
Additionally, every 50 operating hours
- check brushes for wear
- check gear for wear

Technical data

STARMIX 677
Stand 03/2013 -13-