Installation Of Appliance - Maytag MEC5430 Mise En Service

Notice To Installer
Follow accompanying instruction carefully.
CAUTION
Never use a metal blade to pry knob off. If knob
cannot be easily removed, tuck folds of a
dishtowel under knob skirt and pull upward with
steady, even pressure.
Preparation Of Countertop
The cutout in the countertop into which the appliance is to
be installed should be prepared according to the cutout
dimensions given on page 1 of these instructions.
CAUTION
Cutout dimensions are critical. Dimensions
must be measured and cut accurately to within
+ 1/16² (.16 cm) to insure proper fit.

Installation Of Appliance

1. Remove the cooktop from the carton and place it
upside down over two soft pads making sure control
knobs do not interfere with any surface.
2. Provide cutout in countertop as required per page 1.
3. Place unit in the cutout.
4. Make electrical wire connection to unit. Consult local
codes for proper power hook-up.
5. Test to insure control knobs operate all elements
properly.
3