MaxLite 40HMX50 Mode D'emploi

Operating Instructions
MaxLite LED HighMax Bypass Lamps
®
General Safety Information
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
• BEFORE BEGINNING INSTALLATION, SERVICING, OR
PERFORMING ROUTINE MAINTENANCE, PLEASE READ THE
COMPLETE INSTRUCTIONS LIST BELOW.
KEEP THIS DOCUMENT FOR FUTURE REFERENCE.
• THIS LAMP IS NOT RATED FOR USE WITH HID BALLAST OR
EXTERNAL LED DRIVER.
• PROTECT THE LAMP FROM DUST AND DIRT. CLEAN WITH A
SOFT DAMP CLOTH ONLY, DO NOT USE CHEMICAL CLEANERS.
• THIS RETROFIT LAMP IS NOT SERVICEABLE. DO NOT TAKE APART
THE RETROFIT LAMP.
DANGER: RISK OF ELECTRICAL SHOCK
DISCONNECT POWER BEFORE INSTALLATION OR SERVICING
WARNING:
• RISK OF FIRE OR ELECTRIC SHOCK. THIS INSTALLATION REQUIRES KNOWLEDGE OF LUMINAIRES
ELECTRICAL SYSTEMS. IF NOT QUALIFIED, DO NOT ATTEMPT INSTALLATION. PRODUCT MUST BE
INSTALLED IN ACCORDANCE WITH THE NATIONAL ELECTRICAL CODE OR YOUR LOCAL ELECTRICAL
CODE. IF YOU ARE NOT FAMILIAR WITH THESE CODES AND REQUIREMENTS, CONTACT A QUALIFIED
ELECTRICIAN.
DO NOT MAKE OR ALTER ANY OPEN HOLES IN AN ENCLOSURE OF WIRING OR ELECTRICAL
COMPONENTS DURING INSTALLATION.
WARNING:
• TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL
OR ANY OTHER SHARP OBJECTS.
WARNING:
• RISK OF FIRE OR ELECTRIC SHOCK. LUMINAIRE WIRING AND ELECTRICAL PARTS MAY BE DAMAGED
WHEN INSTALLING OF RETROFIT KIT HARDWARE. CHECK FOR ENCLOSED WIRING AND COMPONENTS.
WARNING:
• RISK OF FIRE OR ELECTRIC SHOCK. CHECK THE EXISTING WIRING FOR DAMAGE BEFORE INSTALLING.
DO NOT INSTALL IF EXISTING WIRES ARE DAMAGED.
"THIS LUMINAIRE HAS BEEN MODIFIED AND CAN NO LONGER OPERATE THE ORIGINALLY
INTENDED LAMP," SHALL BE MARKED ON THE LUMINAIRE WHERE READILY VISIBLE BY
THE USER DURING NORMAL MAINTENANCE INCLUDING LAMPING.
40W & 60W: SUITABLE FOR DAMP LOCATIONS. SUITABLE FOR USE IN ENCLOSED LUMINAIRES.
80W & 100W: SUITABLE FOR DRY LOCATIONS. NOT SUITABLE FOR USE IN ENCLOSED LUMINAIRES.
THIS DEVICE IS NOT INTENDED FOR USE WITH DIMMERS.
THIS DEVICE IS NOT INTENDED FOR USE WITH EMERGENCY EXITS.
© Copyright 2018. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 973-244-7300 Fax: 973-244-7333 Email: info@maxlite.com
LED HighMax Bypass Lamps
40HMX50 60HMX50 80HMX50 100HMX50
Picture is for illustration purposes only.
Your model may vary.
Page: 1
REV: 09/14/18