Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
en Automatic switch-off
Displaying the time
Select the kitchen timer with
▶
a The time is displayed for 10 seconds.
Setting the correct time
Select the kitchen timer with
1.
9
Automatic switch-off
If you do not change the settings of a hotplate for a
long time, automatic switch-off will be activated.
When the hotplate switches off depends on the heat
setting selected (1 to 10 hours).
The heat to the hotplate is switched off.
sidual heat indicator / flash alternately on the hot-
plate display.
10
Wipe protection
Wiping over the control panel while the hob is switched
on may alter settings. Your hob has a wipe protection
function to prevent this.
The main switch is excluded from the wipe protection
function. You can switch the hob off at any time.
11
Energy consumption display
This function indicates the total amount of energy con-
sumed between switching the hob on and switching it
off again.
Once switched off, the energy consumption is dis-
played in kilowatt hours, e.g. 1.08 kWh, for
10 seconds.
12
Basic settings
You can configure the appliance to meet your needs.
12.1 Overview of the basic settings
You can find an overview of the basic settings and the
default factory settings here.
Dis-
Selection
play
Automatic childproof lock
– Switched off
– Switched on
– Manual and automatic childproof lock are
switched off.
1
Factory setting
34
.
.
and the re-
1
Set the required time on the control panel.
2.
Switching off the timer signal
You can switch the signal off manually.
Touch any touch field.
▶
a The display goes out and the audible signal ceases.
9.1 Continuing cooking after automatic
switch-off
Touch any control.
1.
a The display goes out.
Reset.
2.
10.1 Activating wipe protection
Touch .
▶
a A signal will sound.
a The indicator lamp above
a The control panel is locked for 30 seconds.
The accuracy of the display depends on various factors
such as the voltage quality of the power supply.
"The display can be activated in the basic settings. "
→ Page 34
Dis-
Selection
play
Signal tone
– Confirmation signal and operating error
signal are switched off. The main switch sig-
nal remains switched on.
– Only the operating error signal is
switched on.
– Only the confirmation signal is switched
on.
– Confirmation signal and operating error
signal are switched on.
1
Factory setting
lights up.
1
Publicité
Chapitres
Table des Matières
Dépannage
